PS Tutorial: A Warm Color Adjustment Effect – Character Color Adjustment-1024programmer

The following are detailed photoshop tutorial steps:
1. Open the original image, use CTRL+J to copy a layer, and change the layer mode to Screen. The effect is as shown below:

,
2. Create a new curve adjustment layer. The parameters are as shown in the figure. After confirming, use a black brush to erase the character’s skin

3. Click the curve adjustment layer 1 mask to load the selection, CTRL+SHIFT+I to invert the selection, and then create a new curve adjustment layer 2 to process the character’s skin. The parameters are as shown in the figure.

4. Create new color balance adjustment layers and photo filters respectively. The parameters and effects are as shown below:

5. Create a new layer, fill it with color #0d1d52, and change the layer mode to exclude. The effect is as shown below:

6. Stamp the layer, draw a white border, and add a lens flare in the upper left corner

7. At this time, I found that the character’s skin was not bright enough, so I stamped the layer, set the layer mode to color filter, set the opacity to 35%, and held down ALT to add a black mask.
Use a white paintbrush to erase the character’s skin

,
8. In order to better highlight the characters, we darken the surroundings of the characters, press Q to enter the quick mask, and select the gradient tool – black and white gradient, radial gradient
, pull out the gradient selection as shown in the picture, press Q again to launch the quick mask, and create a new curve adjustment layer to appropriately reduce the brightness.